Buick 13263279 Motor Assembly, Blower (W/ Impeller)

You can Select Your Vehicle to check if 13263279 fits your vehicle.

To remove the blower motor control module, start by disconnecting the cable from the negative battery terminal. Then, remove the lower insulator panel below the passenger's side instrument panel. Disconnect the electrical connectors to the passenger's side lower airbag and remove the fasteners and airbag from under the glove box. Next, remove the passenger's side instrument panel end cap and the glove box. Disconnect the electrical connectors at the blower motor control module and remove the mounting screws to pull the module out of the housing. For installation, simply reverse the removal steps and reconnect the battery. To remove the blower motor, remove the passenger's side floor air duct fastener and move the duct away from the blower motor. Remove the blower motor cup fasteners and cup from the blower motor. Disconnect the blower motor electrical connector and remove the blower motor fasteners to lower the assembly from the heater case. Installation is the reverse of removal, and don't forget to reconnect the battery.

Yes, if a new control module is being installed, it will have to be programmed and set up by a dealer service department or other qualified repair shop.