Buick 12731742 FILTER-OIL

You can Select Your Vehicle to check if 12731742 fits your vehicle.

These vehicles come with an oil life indicator system which illuminates the light or sends a message on the instrument panel for an oil change depending on the wear of the oil it considers different factors. While this system sounds better than the traditional 3000-mile change, the it usually results in a longer time between the changes and the manufacturer still recommends frequent changes for the health of the engine. If deciding to go by the oil life indicator, use the vehicle up to 7,500 miles before changing the oil. This is because used oil will in most cases cause the engine to wear out due to normal usage beyond the recommended interval. The oil filter is easy to replace and inexpensive, and therefore should be replaced every time the oil is changed. At the beginning position all required tools and supplies, and prepare paper towels and newspaper for accidents. Get the engine up to normal operating temperature, then safely hoist the car up and take off the splash shield. Locate the oil drain plug and the oil filter, and put drain pan under the drain plug and carefully unscrew the plug with the wrench because there are hot oil around the plug. When the liquid is finally emptied, it is prudent to administer some cleaning work on the drain plug before restringing it back again. Place the drain pan below the oil filter, unscrew the oil filter using the oil filter wrench and pour out the used filter into the pan. Crossover the new filter with the old one to check compatibility, clean the area where the filter is mounted and check on the condition of the rubber gasket to know if it has bond. Dip the new filter's gasket in clean oil, then secure it, as per the manufacturer's guidelines, and then lower the vehicle. Pour the correct quantity of fresh oil, look at the dip stick and start the engine slightly so that as to check the drips. Check the level of the oil again after some few minutes and add more oil if there is need. It is probably best to keep an eye on the quantity of oil after the first few trips, and listen for leaks. The old oil should be dumped carefully, or it should be recycled since it should not be poured down drains or on the ground. The 'Oil Life Monitor' monitors engine conditions and will prompt when it is need of an oil change. Once the oil has been changed and the filter replaced, continue with the Oil Change reminder system by turning the ignition to run, pressing the accelerator pedal depress 3 times followed by turning the key start the engine. If the indicator remains on, try again the reset procedure.

The oil filter should be replaced with every oil change to ensure optimal engine performance.

Resetting the oil life monitor involves specific steps depending on the model year, including using the Driver's Information Center or pressing the accelerator pedal in a sequence for models without it.

While the oil life indicator may allow for longer intervals between oil changes than the traditional 3000-mile recommendation, it is advised not to exceed 10,000 miles before an oil change, regardless of the indicator.

After removing all tools and rags, lower the vehicle and pour fresh oil through the filler opening, checking the level on the dipstick after allowing it to settle. Run the engine briefly and check for leaks, then monitor for leaks and oil level during the first few trips.

Warm up the engine, gather the required oil, locate the oil drain plug and filter, drain the old oil into a pan, clean the drain plug, reinstall it, remove the old filter, clean the mounting area, install the new filter after applying a light coat of oil to its gasket, lower the vehicle, add the specified amount of fresh oil, check the oil level, start the engine briefly, and check for leaks.

Regular oil changes and maintenance are essential for engine longevity and performance because they help keep the engine lubricated with clean oil, prevent premature wear, and ensure the engine operates at its best. This contributes to overall vehicle reliability and efficiency.

The old oil should be disposed of properly by recycling it at a designated facility.