Buick 18015427 Caliper,Front Brake (LH)

You can Select Your Vehicle to check if 18015427 fits your vehicle.

To remove the caliper, follow steps 2-4 of pad replacement, then take out the inner pad, spring clip, and L-shaped retainer. Clean the caliper with denatured alcohol, discard the brake hose copper gasket, and empty the caliper brake fluid. For installation, attach the brake hose with a new gasket, lubricate sleeves and bushings, fit bushings and disc pads, remount the caliper, reconnect brake hose, insert the retainer clip, bleed brakes, and test the vehicle. To overhaul, shield the piston with wood, eject using compressed air, remove the dust boot and bleeder screw, inspect piston and caliper bore. Clean reusable parts, fit new seals, lubricate the caliper bore, reassemble the caliper, install pads, bleed brakes, secure the wheel, and test drive.

To get started with the removal of brake caliper for overhaul, open the brake fluid reservoir and check its level if needed. Then, loosen wheel lug nuts, jack up a vehicle as well as remove the wheels. After that, bottom the piston in the caliper bore and clean it before any hose is disconnected. Lastly, take out mounting bolts and separate caliper from automobile. The replacement will start by taking off brake pads and cleaning outside of calipers. While removing pistons from calipers using compressed air be cautious not to damage them. Take out dust boot and piston seal throwing away any rubber parts. All components are washed and reviewed for possible damages on both piston as well as caliper bore lineages. Lubricate piston bores along with seals then assemble caliper using new bushings plus sleeves For fitting purposes confirm availability of mounting bolts while pushing back piston into its bore where required Place caliper over rotor together with mounting bracket then tighten bolts after checking clearance Install brake hose while bleeding brakes Ditto; finally install wheels lower vehicle and pump brake pedal ensuring contact between pads & rotor.

Before removing the brake caliper for overhaul, you should remove the cover from the brake fluid reservoir and adjust the fluid level if necessary.