My Garage
My Account
Cart
Genuine Pontiac Phoenix Clutch Cable
Clutch Cable Wire- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Clutch Cable found
Pontiac Phoenix Clutch Cable
The Clutch Cable that is used in Pontiac Phoenix vehicles helps to effectively engage the engine to transmission thus gives control during gear changes as well as low speed movements. This component is mechanically easily worn out due to constant use over a period and therefore the need to replace this component from time to time to enable effective functioning of the whole system. In cars sometimes there is a problem with Clutch Cable which results in poor communication between the clutch and the transmission, that is why when the Clutch Cable is replaced very quickly, it allows the power to be smoothly transferred from the transmission to the engine.
Each OEM Pontiac Phoenix Clutch Cable we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Pontiac Phoenix Clutch Cable Parts Questions & Experts Answers
- Q: How to disengage and install a clutch cable?A: Disengage the clutch cable from the clutch release lever at the transaxle, taking care not to allow the cable to snap backward toward the rear of this vehicle when it is disconnected because that can damage the quadrant in the self-adjusting mechanism. Then, lift away from the quadrant, and take off the locking pawl from it so that you can slide out on its right side without any problem. After that, go back to the engine compartment and remove two upper nuts that hold down cable retainer against upper mounting stuns of clutch cable bracket located on firewall. Unhook the transaxle mounted bracket to release cable; then remove it completely. Put on gasket on 2 upper mounting studs for clutch cable bracket as well as insert new cable into firewall and bracked until flange on cable retaining comes into contact with gasket. Attach pawl securely before connecting a wire through an opening at its bottom part and then along its top edge of quadrant. Use torque wrench to ensure tight fit of 2 top nuts which are mounted on retainer studs. Connect a wire into a transaxle fastened bracket with nut mounted thereon. Connect a wire without pulling it firmly on a step of one quadrant because this will cause breakage.
