My Garage
My Account
Cart
Genuine Pontiac Fiero Parking Brake Cable
Emergency Parking Brake Release Cable- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
5 Parking Brake Cables found
Pontiac Fiero Cable Assembly, Parking Brake Rear
Part Number: 10200441$21.27 MSRP: $40.14You Save: $18.87 (48%)Ships in 1-2 Business Days
Pontiac Fiero Parking Brake Cable
The Parking Brake Cable used on Pontiac Fiero cars is responsible for parking brake mechanism which allow the car to remain stationary when parked especially on a slope. This cable links the parking brake, which is also termed as the emergency brake or handbrake, to the other braking system and is definitely an important component. Years of production may have seen Pontiac Fiero utilize various styles of Parking Brake Cable and its purpose is basically to act on the parking brakes well. Parking Brake Cable is crucial to the correct function so if it gets old or stretched it may not hold the parking brake firmly enough creating some possible dangers. Should any part of the Parking Brake Cable fails it becomes impossible to use the parking brake at all which shows how crucial it is to ensure that Pontiac Fiero cars are checked up often for any faults.
Each OEM Pontiac Fiero Parking Brake Cable we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Pontiac Fiero Parking Brake Cable Parts Questions & Experts Answers
- Q: How do you remove and install the parking brake cable on Pontiac Fiero?A: To dismantle remove the parking brake cable the following procedure should be followed; the vehicle should be lifted off the ground using a jack and properly supported by jackstands. Turn counterclockwise the adjusting nut at the equalizer and pull the cables apart by unscrewing the threaded bolt on the adjuster nut. If you backed off or disconnected the adjuster nut then you should remove the cable clips and the bolts that retain the retaining clip in the left wheel well and then the car can be lowered. Cut off the boot and parking brake with an armado then unscrew the bolt of the seat belt and take off the carpet finishing molding which has pop fasteners. Then, then remove the shoulder harness retaining bolt and the quarter trim finishing molding, retract the carpet to see the path where the cable will go, and then remove the cable from the parking brake lever and then pass it through the car body. For installation, run entire new cable and fix the forward end to the parking brake hand lever properly engaging it in the slot provided at the base of the lever pivot. Replace the carpet and fit the quarter trim finish molding before fitting the shoulder harness retaining bolt; this bolt should then be tightened. Fit the seat belt bolt and carpet finish molding and locate the parking brake boot at the parking brake hand lever. Lift the vehicle once again and place it on the jack stands, secure the cables by installing the two retaining clip bolts which are available at the left wheel well and also the cable clips. Last but not the least, fix the right rear caliper cable in the cable adjuster and then engage the equalizer nut in the nut seat such that all the available slack in the cable is utilized.
