When repairing 2010 and later models, before installing the hood latch, use a marker to draw a line around the latch and bolt heads on the open hood to guide exact placement later. Unplug the power cables from the hood latch area by using a long Phillips head screwdriver or trim tool. Firstly, remove the fastener holding the cable to the hood latch opening, and then pull out the cable's electrical connection from behind the radiator support. Gently pry off the bolts holding the hood latch to its spot on top of the radiator support, then remove the latch. Pull the latching wire off the handle by pulling it loose there. To install, just put everything back the way it came out. To fix the Hood Cable inside the vehicle, pull it from the holder, slide it out of the handle. Remove the Hood Cable from its connection point with the latch; peel off the retaining clips from both the radiator support and inside edge of the fenderwell; remember that to reach these clips you'll need to take off the front
Bumper cover; pictured below, for information. Installation is again the reverse of removal.