Genuine Chevrolet Tracker Turn Signal Flasher

Chevrolet Tracker Turn Signal Flasher Parts Questions & Experts Answers

• Flasher,Turn Signal Lamp
  91177630
  Q: What is the function and replacement process of the turn signal flasher on Chevrolet Tracker?

  A: The turn signal flasher is usually a small canister or a box-shaped unit generally positioned in or around the Fuse block and with later models the turn signal and hazard only flasher are usually combined into a single unit. In its normal condition, a clicking sound can be heard during its operation; If the turn signals fail on one side along with the flasher does not click then there is, probably, a defective turn signal bulb present. If both the turn signal lights do not blink the cause may likely be a blown fuse, a defective flasher unit, a bad switch or a bad connection. An electrical check of the car can show a problem of a turn signal fuse which could be blown, however, before replacing the new one, one should check the wiring for shorts. To remove the flasher, you just pull it out from the fuse block or wiring harness and ensure that you get the correct unit before fitting it for which you have also to reverse the removal process. On the later models, the hazard flasher co-ordinates with the turn signal flasher and causes all four turn signals to flash at once. It is checked in the same manner as the turn signal flasher, while to replace it, it is pulled out of the back of the fuse block as previously described, with the only precondition being that the new unit is to be an exact swap for the old unit, which also follows the reverse procedure of pulling.