Q: How do you remove the air intake duct and air filter housing?
A: To start removing the air intake duct, first of all, disconnect PCV fresh air inlet hose. After this, unscrew the hose clamp screw at the air filter box and retract the collar. Then, unscrew the hose clamp screw at the Throttle Body, retract its collar and remove it from where it is connected to. To install it back, just follow these steps in reverse order. To get rid of an air filter box, you begin with disconnecting a cable from negative terminal of a battery.Then take off an air intake duct and unplug the electrical connector from the MAF sensor.Remove left front diagonal brace next after that remove air filter element.Pull off upper part of air filter box then detach electrical connectors from TCM or/and PCM.Remove TCM and PCM from an air filter box then pull out TCM/PCM harness from lower part of box.The lower part of an air filter box is secured by locator pins pushed into rubber mounting grommets whereby it can be lifted straight up to get rid of them.Inspect rubber mounting grommets when having taken out an entire air-filter box as one defective one will call for replacement.Installation is opposite to removal.