What is the purpose and location of the Throttle Position Sensor (TPS) for Chevrolet C1500 and K1500?

The throttle position sensor (TPS) is a variable potentiometer connected to the end of the throttle shaft on the throttle body. It monitors the output voltage to determine fuel delivery based on throttle valve angle. Intermittent bursts of fuel and an unstable idle are signs of a broken or loose TPS. The TPS is positioned on the side of the throttle body. Loose terminations or broken wires should be checked. Before checking the TPS, ensure that there is correct functioning of the voltage supply and ground circuits. Disconnecting the electrical connector will enable you to check its voltage, which should be approximately 5.0 volts. If it's wrong then you must check your wiring. To test TPS operation, reconnect your connector and then back probe the dark blue wire terminal. Gradually open the throttle and observe whether voltage increases smoothly or not? If it does not, replace it with correct one because faulty ones can cause incorrect readings when testing for fuel injection problems in your car's engine system such as too much or too little fuel being delivered into cylinder at any given point in time; this may result in poor performance levels during acceleration process by reducing power output produced from motors while driving along highways, streets etc., which will ultimately affect overall speed achieved at any moment under different conditions depending upon circumstances surrounding its usage within community members living area around us today so make sure everything goes well before something bad happens again due certain reasons whatsoever throughout entire life span till Death do part away eventually without warning sometimes!) To replace your Throttle Position Sensor (TPS), access it by removing what needs to be removed first. At present you can disconnect electrical connector and remove mounting screws also. Remember to put a new O-ring in place on top before tightening down screws, as well as making sure that TPS aligns properly with throttle shaft prior tightening up all bolts.

Genuine Chevrolet K1500 Throttle Position Sensor

TPS Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Throttle Position Sensors found

View related parts
Chevrolet K1500 Sensor,Throttle Position
Part Number: 17106681
$45.64 MSRP: $94.76
You Save: $49.12 (52%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: SENSOR KIT, Multi Port Fuel Injection Throttle Position; Throttle Position Sensor
- Replaces: 17112404, 17112679, 17087653
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1988-1995 Chevrolet K1500 | K1500 EXTENDED CAB LONG BOX, K1500 EXTENDED CAB STANDARD BOX, K1500 REGULAR CAB LONG BOX, K1500 REGULAR CAB STANDARD BOX | 6 Cyl 4.3L, 8 Cyl 5.0L, 8 Cyl 5.7L, 8 Cyl 6.2L Diesel
View related parts
Chevrolet K1500 Sensor,Throttle Position
Part Number: 17123852
$35.96 MSRP: $79.62
You Save: $43.66 (55%)
ADD TO CART
Product Specifications
- Other Name: SENSOR, Multi Port Fuel Injection Throttle Position; Throttle Position Sensor
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1996-1999 Chevrolet K1500 | K1500 EXTENDED CAB LONG BOX, K1500 EXTENDED CAB STANDARD BOX, K1500 REGULAR CAB LONG BOX, K1500 REGULAR CAB STANDARD BOX | 6 Cyl 4.3L, 8 Cyl 5.0L, 8 Cyl 5.7L
View related parts
Chevrolet K1500 Sensor Assembly, Throttle Position
Part Number: 10137417
$184.07 MSRP: $591.92
You Save: $407.85 (69%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: SENSOR, Multi Port Fuel Injection Throttle Position; Throttle Position Sensor
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1993 Chevrolet K1500 | K1500 EXTENDED CAB LONG BOX, K1500 EXTENDED CAB STANDARD BOX, K1500 REGULAR CAB LONG BOX, K1500 REGULAR CAB STANDARD BOX | 8 Cyl 6.2L Diesel
- 1988-1991 Chevrolet K1500 | K1500 EXTENDED CAB LONG BOX, K1500 EXTENDED CAB STANDARD BOX, K1500 REGULAR CAB LONG BOX, K1500 REGULAR CAB STANDARD BOX | 8 Cyl 6.2L Diesel
View related parts
Chevrolet K1500 Sensor Kit, Throttle Position
Part Number: 17111471
Product Specifications
- Other Name: SENSOR KIT, Multi Port Fuel Injection Throttle Position; Throttle Position Sensor
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1988-1991 Chevrolet K1500 | K1500 EXTENDED CAB LONG BOX, K1500 EXTENDED CAB STANDARD BOX, K1500 REGULAR CAB LONG BOX, K1500 REGULAR CAB STANDARD BOX | 6 Cyl 4.3L, 8 Cyl 5.0L, 8 Cyl 5.7L, 8 Cyl 6.2L Diesel
View related parts
Chevrolet K1500 Sensor Assembly, Throttle Position
Part Number: 14071076
Product Specifications
- Other Name: SENSOR, Multi Port Fuel Injection Throttle Position; Throttle Position Sensor
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1988-1993 Chevrolet K1500 | K1500 EXTENDED CAB LONG BOX, K1500 EXTENDED CAB STANDARD BOX, K1500 REGULAR CAB LONG BOX, K1500 REGULAR CAB STANDARD BOX | 8 Cyl 6.2L Diesel
View related parts
Chevrolet K1500 Sensor Kit,Tbi Throttle Position
Part Number: 17111787
Product Specifications
- Other Name: SENSOR KIT, Multi Port Fuel Injection Throttle Position; Oxygen Sensor, Throttle Position Sensor
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1988-1991 Chevrolet K1500 | K1500 EXTENDED CAB LONG BOX, K1500 EXTENDED CAB STANDARD BOX, K1500 REGULAR CAB LONG BOX, K1500 REGULAR CAB STANDARD BOX | 6 Cyl 4.3L, 8 Cyl 5.0L, 8 Cyl 5.7L, 8 Cyl 6.2L Diesel

Chevrolet K1500 Throttle Position Sensor

In Chevrolet K1500, Throttle Position Sensor (TPS) is an important part of the Vehicle's fuel management system, which measures the position of the throttle and feeds back to the system the position of throttle to enable it to adjust the fuel/air mixture for combustion. Usually an electromechanical type of this sensor, based on the non-contact type such as a Hall Effect sensor or magnetoresistive, sends information directly to the fuel injection system to provide the required power to the engine. In electronic throttle control systems, therefore, the "Throttle Position Sensor," or TPS, guarantees dynamic accelerating, steady-speed running, and coasting by continually computing the necessary fuel volume. TPS may deteriorate, hence reducing fuel efficiency and performance hence the need for replacement in case of deterioration.

Each OEM Chevrolet K1500 Throttle Position Sensor we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.

Chevrolet K1500 Throttle Position Sensor Parts Questions & Experts Answers

Sensor,Throttle Position
17106681
Q: What is the purpose and location of the Throttle Position Sensor (TPS) for Chevrolet C1500 and K1500?
A: The throttle position sensor (TPS) is a variable potentiometer connected to the end of the throttle shaft on the throttle body. It monitors the output voltage to determine fuel delivery based on throttle valve angle. Intermittent bursts of fuel and an unstable idle are signs of a broken or loose TPS. The TPS is positioned on the side of the throttle body. Loose terminations or broken wires should be checked. Before checking the TPS, ensure that there is correct functioning of the voltage supply and ground circuits. Disconnecting the electrical connector will enable you to check its voltage, which should be approximately 5.0 volts. If it's wrong then you must check your wiring. To test TPS operation, reconnect your connector and then back probe the dark blue wire terminal. Gradually open the throttle and observe whether voltage increases smoothly or not? If it does not, replace it with correct one because faulty ones can cause incorrect readings when testing for fuel injection problems in your car's engine system such as too much or too little fuel being delivered into cylinder at any given point in time; this may result in poor performance levels during acceleration process by reducing power output produced from motors while driving along highways, streets etc., which will ultimately affect overall speed achieved at any moment under different conditions depending upon circumstances surrounding its usage within community members living area around us today so make sure everything goes well before something bad happens again due certain reasons whatsoever throughout entire life span till Death do part away eventually without warning sometimes!) To replace your Throttle Position Sensor (TPS), access it by removing what needs to be removed first. At present you can disconnect electrical connector and remove mounting screws also. Remember to put a new O-ring in place on top before tightening down screws, as well as making sure that TPS aligns properly with throttle shaft prior tightening up all bolts.