My Garage
My Account
Cart
Genuine Chevrolet HHR Control Arm
Suspension Arm- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
4 Control Arms found
Chevrolet HHR Control Arm
Chevrolet HHR's Control Arm is an important part of the connection between the frame and wheels and contains shock absorbers and springs among other items. These arms rotate in relation to the road situation and thus adjust motion of the wheels in vertical direction. No matter the type of control arm, they will have the bushing on the area in which it connects to the frame and on the area where is connects to the knuckle or axle, the ball joint will be present. Later versions of HHR models can use solid casted iron or aluminum control arms for strength and less weight. Standard control arms may not be suited for handling greater power and forceful control of the car as well as fast driving; hence, there exist performance control arms that have specific alignment angles and enough space to accommodate larger rims and tires.
Each OEM Chevrolet HHR Control Arm we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Chevrolet HHR Control Arm Parts Questions & Experts Answers
- Q: How do you remove the control arm?A: Start by loosening the wheel lug nuts on the side where the control arm is to be removed. To begin, loosen the lug nuts of the wheel that you are disassembling and apply parking brake. You may now lift front part of your vehicle off ground using jacks then take off its wheel. Afterward, pull it out from the Steering Knuckle and pry apart its ball joint and then remove pinch bolt that holds balljoint on control arm. Then remove bolts holding control arm to subframe, and finally remove control arm itself. Check control arms for distortion and bushings for wear; replace necessary parts. Do not try an attempt to straighten a bent control arm. If any cracks are found or wear signs are observed in busings, take the entire assembly to your local automotive machine shop where they will have bushings replaced with new ones. As for installing control arm, perform removal procedure in reverse order while ensuring all fasteners are torqued properly. Lower vehicle, install lug nuts and tighten them appropriately according to recommended torque values; lower vehicle body after tightening lug nuts provided above. Finally, check alignment of front wheels again aligning when necessary following this exercise too as advised by some recommendations available at work places like auto repair shops near me.
