My Garage
My Account
Cart
Genuine Chevrolet HHR Brake Pad
Disc Brake Pad Set- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
4 Brake Pads found
Chevrolet HHR Pad Kit, Front Disc Brake
Part Number: 22820406$74.54 MSRP: $147.87You Save: $73.33 (50%)Ships in 1-2 Business Days
Chevrolet HHR Pad Kit, Front Disc Brake
Part Number: 25808929$170.20 MSRP: $337.69You Save: $167.49 (50%)Ships in 1-2 Business Days
Chevrolet HHR Brake Pad
Chevrolet HHR Brake Pad are one of the car's braking systems meant to press against the rotating brake discs and decrease activity through heat vitality. These pads are generally constructed from metals and synthetic products due to their ability to endure high temperatures during its daily use, that is up to 400 degrees Fahrenheit approximately. Brake pads comprise of steel backing plates with friction material that wears down to the rotor to produce the friction needed for arresting the vehicle's motion. The various brake pads which are available are the non metallic, semi metallic, fully metallic and the ceramic brake pads which have their key features in friction balance, wear and noise. Brake pad replacement is standard since they wear out constantly, affecting the resistance force, safety, and signaling when it is time to change them. Brake pads are one of the key components where decisions about their specification may affect a vehicle's behavior, such as brake fade or excessive rotor wear, and the specification of brake pads is likely to be affected by environmental rules.
Each OEM Chevrolet HHR Brake Pad we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Chevrolet HHR Brake Pad Parts Questions & Experts Answers
- Q: How do I remove Brake Pad?A: To remove all components except for Brembo brakes, start by removing the cap from the brake fluid reservoir. Then, loosen the wheel lug nuts and raise the vehicle, supporting it securely on jackstands. Remove the wheels and inspect the Brake Disc. Use a C-clamp to push the piston back into its bore, making sure the fluid in the master cylinder doesn't overflow. Rotate the caliper away from the disc and remove the outer brake pad, followed by the inner pad. Inspect and replace the support plates if necessary, and lubricate the contact areas on the mounting bracket. For installation, apply anti-squeal compound to the new brake pads and rotate the piston on rear calipers. Install the inner pad with the brake wear sensor positioned correctly, then install the new outer pad. Clean and lubricate the caliper guide pins before installing them, and tighten the guide pin bolts to the specified torque. After completing the job, depress the brake pedal to bring the pads into contact with the disc and check the brake fluid level and operation of the brakes before normal use. For removal with Brembo brake pads, follow the same initial steps of removing the cap, loosening lug nuts, raising the vehicle, and removing the wheels. Inspect the brake disc and then use a punch and hammer to remove the lower caliper guide pin and pad retainer. Remove the upper caliper guide pin and push the caliper pistons back into their bores. Finally, remove the pads from the caliper. To install the new pads, clean the caliper assembly and then reverse the removal steps. After completing the installation, depress the brake pedal to bring the new pads into contact with the disc, check the brake fluid level, and carefully test the brake operation before normal use.
