A: To remove the front cable, take off the rear console trim, detach the cable nut from the handbrake, and push the cable assembly through the floor. Raise and support the vehicle. Pull the cable housing from the guide near the exhaust pipe heat shield, slide it from the equalizer, and disconnect from the joiner. Reverse steps to install and adjust the cable. For the left cable, lift the vehicle, loosen the equalizer, and disconnect the cable. Remove the brake drum and shoes, then release the parking brake cable from its lever. Push the cable through the backing plate. To install, reverse and adjust. The right cable follows a similar procedure: lift the vehicle, release tension, and disconnect the cable. Remove the brake components and push the cable through the backing plate. Reverse steps to install and adjust.