My Garage
My Account
Cart
Genuine Cadillac DTS Water Pump
H2O Pump- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Water Pump found
Cadillac DTS Water Pump Assembly
Part Number: 12583033$162.61 MSRP: $322.64You Save: $160.03 (50%)Ships in 1-2 Business Days
Cadillac DTS Water Pump
The Water Pump in Cadillac DTS cars aids in circulation of coolant from the radiator to the engine to sop up heat formed during combustion. Almost all the modern water pumps are made up of aluminum casting having a rotating shaft and an impeller for the purpose of moving the coolant. The signs that a vehicle water pump is failing are, leakage, noise due to the bearing failure and excessive heating of the engine. High flow water pumps are used for high-performance engines as they provide more flow through the coolant and pull less power. Other electrical loads are water pumps for Matters such as independent coolant circulating and post-engine-shutdown cooling. Water pumps may be of modified Original Equipment or cast iron, or a completely custom fabricated aluminum one depending on the requirements of the kind of engine and horsepower.
Each OEM Cadillac DTS Water Pump we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Cadillac DTS Water Pump Parts Questions & Experts Answers
- Q: What are the ways to check the operation of the water pump and what are the signs of a defective water pump on Cadillac DTS?A: A failure in the water pump can lead to engine damage and if it is found to be defective, it should be replaced with a new or rebuilt unit. In the event of a water pump seal failure, coolant will leak out at the left front of the engine, between the cylinder head and the coolant crossover housing. It is important not to mistake drive belt slippage, which causes a squealing sound, for water pump bearing failure. A quick check of water pump performance can be done by putting the heater on, as a corroded impeller in the pump may prevent efficient circulation of hot coolant.
- Q: How do I remove and install a water pump on Cadillac DTS?A: To start removing the water pump, disconnect the battery's negative terminal cable. Now drain coolant fluid and remove the water pump drive belt, which is situated behind the coolant crossover assembly. To access it you are supposed to remove the drivebelt shield. After that, if equipped, get rid of the air filter housing and secondary AIR check valve bracket from the coolant crossover housing. Separate the lower radiator hose from thermostat housing and take off water pump bypass hose from coolant crossover assembly. Now remove water pump cover by using a clockwise rotating tool called a water pump removal tool before taking it out of its house. Clean mating surfaces of coolant crossover housing and cover to remove any residue left on them. For a new water pump installation, put another o-ring in a groove of a coolant-pipe housing first. Then after placing slotted tangs with the housing install new water pump as well as aligning them into place. In order to lock it, use special tool which should be turned counterclockwise for specified torque at least or more than once when needed. Put another o-ring in a groove of water pump cover and bolt up to specified torque values being mentioned in this case later on bring your engine parts back together down mechanically making sure all fasteners are tight enough before you finally have to refill cooling system start up motor look around see if anything leaks out.
