My Garage
My Account
Cart
Genuine Cadillac DTS Door Lock Cylinder
Door Lock Cylinder Tumbler- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Door Lock Cylinder found
Cadillac DTS Cylinder Kit, Front Side Door Lock (Uncoded)
Part Number: 25979745$89.42 MSRP: $133.69You Save: $44.27 (34%)
Cadillac DTS Door Lock Cylinder
Cadillac DTS Door Lock Cylinder is a part positioned in the front door that provides for locking and unlocking of the car using the key. While there has been a move from the use of keyless entry systems commonly used today, most car models, including Cadillac DTS have door lock cylinder. These cylinders can degrade over time especially the locks on the doors and create challenges in locking or unlocking the doors, and problems with fitting and removing keys. In order to ensure that your door lock cylinder does not compromise the security or functionality of your vehicle, is recommended that you replace a faulty one if needed.
Each OEM Cadillac DTS Door Lock Cylinder we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Cadillac DTS Door Lock Cylinder Parts Questions & Experts Answers
- Q: How to remove the door latch, door lock cylinder, outside handle, and inside handle?A: Initially, raise the window and then remove the door trim panel to take off the door latch. Next, unscrew those screws that hold the latch in position on the door. In addition, through this entrance to the big hole; you can situate the latch in order to disengage outside handle of a door, outside lock cylinder and inside handle rods. Also, disconnect the rod of actuator for door lock and slip out latch assembly from within the door after that. After raising the window and removing both water shield and door trim panel, one can take out outer handle along with lock cylinder on older models or nuts plus lock cylinder itself. However, in newer models undo nuts before taking away lock cylinder or even removing it first followed by other parts such as outside handles. Using a socket plus extension wrench, unlock nuts or bolts holding outside handle on place then if there are any clips retaining it push against them upwards to release this external grip. Subsequently remove the inner handle by pulling out all connecting rods from its backside once again after opening up water shield with aid of similar step used earlier for two types of this inner kind prior showing how fasteners were fixed previously; remove rivets meaning unfasten bolts at connection where puller's fulcrum existed also have been provided or got milled down amongst others because these could be used instead besides being cut through; whereas finally during installation opposite sequence as used while removing should be applied which means they ought to do exactly opposite but yet same way like shown above.
