Q: How to remove and install a wiper motor and linkage assembly?
A: Afterwards, remove the nuts as well as the windshield wiper arms that have been attached. Cowl covers must be removed. Moreover, to detach the wiper motor cover one should remove the bolts/nuts and remove the wiper motor cover. When it's necessary, turn the linkage so that it prevents the wiper arm from entering Park position while cleaning. On its own, unfasten the grommet of the wiper motor electrical harness and press down firmly on it into the cowl plenum. Loosen out and rinse away any dirt on these screws referred to as "wiper motor/linkage retaining bolts". On top of that, if you disconnected it from another part to allow easier installation, then use a bolt to attach it to its holder; otherwise, hold back from doing this yet. Detach linkage drive link which is connected with a wiper motor arm. Undo all screws and separate from each other: Wipe Motor from Wipe Linkage Assembly. It's just like taking away what we did prior.